Garland Shower Refinishing — Permanent Porcelain Glaze, Not Acrylic Urethane
Garland Shower Refinishing — How Fusion Lock™ Corrected a Failed Inferior Refinishing Job
In today’s video filmed near Lake Ray Hubbard in Garland TX, I show a shower that was refinished just one year ago with standard epoxy paint. It was already peeling, cracking, and lifting in large areas. I sanded everything down, removed the runs, applied Fusion Lock™ for a chemical bond, and refinished the entire shower with a high-tensile-strength porcelain glaze. The results were night and day.
Garland Shower Refinishing — Common Questions
Can you refinish a shower that was already painted or refinished before?
+
Yes. Many Garland showers were previously painted with epoxy or acrylic urethane.
I remove the failing areas, sand and strip it back, apply my Fusion Lock™ bonding
system, and refinish the shower with a permanent porcelain glaze for a uniform,
high-gloss finish that prevents mildew growth on the grout lines.
How long before I can use my refinished shower?
+
You can gently return the shower to use in about 24–30 hours. It will be read for use the day after it is refinished! Plus no Isocyanates means Low V.O.C. residual odor dissipates in about 1 hour.
What is the difference between acrylic urethane paint and your porcelain glaze?
+
Acrylic urethane is a paint. Porcelain Glaze is croo linked with polyester, the tensile strength is remarkable! Just see the chart below. My process uses Fusion Lock™ to chemically bond a
polyester porcelain glaze into the surface, giving you true restoration instead
of repainting.
Can refinishing fix peeling, runs, or rough spots from a previous company?
+
Yes. This Garland shower near Lake Ray Hubbard had peeling epoxy and visible runs.
I sanded the bad areas, feathered the old coating, applied a Fusion Lock™ tie coat,
and refinished the entire shower so everything matched from floor to ceiling.
Do you only work in Garland or surrounding areas too?
+
Garland is one of my regular areas — including Lake Ray Hubbard and Firewheel.
I also refinish tubs, tile, and showers in Dallas, Mesquite, Richardson, Rowlett,
Rockwall, Plano, and all around, including Dallas. Text me pictures and a zip code for an exact quote.
Tensile Strength: 67.85 MPa (≈9,840 psi) — Is that good?
| Coating Type | Typical Tensile Strength (MPa) | Notes |
|---|---|---|
| Standard Epoxy (2-part) | 30–50 | Softer feel; moisture and yellowing risk over time. |
| Acrylic Urethane (iso-cured) | 40–60 | Glossy; flexible; humidity-sensitive long term. |
| Powder Coat (poly/epoxy hybrid) | 55–70 | Tough; requires ~350–400 °F oven cure. |
| Factory Porcelain Enamel | 65–90 | Glass-ceramic fused at 1400 °F+; very hard, can chip if struck. |
| Silane/Ceramic Hybrid Glaze (e.g., Fusion Lock™) | 65–75+ | Self-etch adhesion + silane bonding; porcelain-hard with impact forgiveness. |
| Your Tested Coating | 67.85 MPa | ✅ In the porcelain-class range — excellent real-world durability. |
- What it means: High resistance to cracking or pulling apart under stress.
- Homeowner upside: Better long-term adhesion, fewer edge chips, stable gloss after cure.
- Context: Numbers are typical ranges; actual performance also depends on prep, bonding, and cure.
